custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board
custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board
custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board
  • Load image into Gallery viewer, custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board
  • Load image into Gallery viewer, custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board
  • Load image into Gallery viewer, custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board

custom 1Pcs Pam8302a CJMCU-832 2.5w single channel class d power amplifier module audio development board

Regular price
$0.90
Sale price
$0.90
Regular price
$2.90
Sold out
Unit price
per 

We are a manufacturer of electronic components, electronic modules for a large number of products.We are the factory!With more than 10 years of PCB development experience, the product quality is good, the price is excellent.A large number of wholesale sales of global buyers, welcome to purchase.


This super small mono amplifier is surprisingly powerful - able to deliver up to 2.5 Watts into 4-8 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.0V-5.5VDC. Since the amp is a class D, its very efficient (over 90% efficient when driving an 8Ω speaker at over half a Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. There's even a volume trim pot so you can adjust the volume on the board down from the default 24dB gain. This board is a welcome upgrade to basic "LM386" amps! CJMCU
 
The A+ and A- inputs of the amplifier go through 1.0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the Audio- pin  to ground. The output is "Bridge Tied" - that means the output pins connect directly to the speaker pins, no connection to ground. The output is a high frequency 250KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly. CJMCU
 
Comes with a fully assembled and tested breakout board. We also include header to plug it into a breadboard and a 3.5mm screw-terminal blocks so you can easily attach/detach your speaker. You will be ready to rock in 15 minutes! Speaker is not included, use any 4 ohm or greater impedance speaker.
 
Output Power: 2.5W at 4Ω, 10% THD, 1.5W at 8Ω, 10% THD, with 5.5V Supply
50dB PSRR at 1KHz
Filterless design, with ferrite bead + capacitors on output.
Fixed 24dB gain, onboard trim potentiometer for adjusting input volume.
Thermal and short-circuit/over-current protection
Low current draw: 4mA quiescent and 1uA in shutdown mode